Full Spectrum Laser Training

Learn how to engrave (and cut) with a 40W Laser Cutter! This class is MANDATORY in order to operate the Full Spectrum laser. While non-members may take the class, membership at MakeIt Labs is required for access to the laser outside of class. Students are encouraged to farmiliarize themselves with the Full Spectrum software and documents in advance of the class (see Full Spectrum Wiki). At this time, This class is ONLY available to Make It Labs Memebers. PREREQUISITES: Anyone taking this class must have already taken the intro/authorization class for the Rabbit laser, and be experienced and knoweldgable in it’s operation. SCOPE: This will be a basic authorization class to teach you the basics of operating this particular laser. It will not be comprehensive class on general materials, practices, outside software and image preperation. The Full Spectrum is primarily an engraving laser, and thus will focus on that. This class covers: SafetyFor You and the Laser Using Retnia EngraveCreating DesignsImporting DesignsSetting Cut/Engrave ParametersUploading Jobs to the Laser Setting up the LaserPositioning the Work PieceSetting FocusChecking Project DimensionsVerify Chiller, Blower, Exhaust Before Class Get the most out of your class! Check out the Laser Wiki ahead of time – and farmiliarize youself with what you will be going over. Full Spectrum Wiki Page You are encouraged to download and read the manuals, and install and farmiliarize yourself with the software ahead of the class! Non-Members At this time, this class is ONLY available for Make It Labs members. Fievent.com | Contact | Privacy | Terms